High-Wing XL

This kit may hold an airplane weighing up to 15 pounds by its wing.  it is composed by a 3D printed top pin, a 17.7 inches rod, 4 clamps and 2 3D printed wing holders with a 3mm carbon fiber reinforcement.
 
the Internal dimentions are 3'' wide, 2.5'' height and 6.5'' deep.  
These pictures are with a complete system, using a ceiling adapter, foam pads of 3''x15'' each, buckles  and hook and loop.  
 
The Ceiling adapter is required to hang the plane on the ceiling. Who already have a Fuselage Hanger  may use the kit to hang below another airplane and on this case, the ceiling adapter is not required.
 
FOAM PADS can be included to stay between the hanger and the wing, protecting the airplane paint and cover from scratches.  
 
CARBON FIBER BUCKLE, the hanger can have a 4 buckles (2 per holder) added to it, to adapt the hook and loop or belt behind the wing avoiding the plane to slide backwards when being hung. 
 
ONE SIDE hook and loop : This hook and loop can be used with the buckle avoiding the plane to swing backwards. Our hook and loop have a soft back side what doesn't scratch the plane.
When measuring remember the holder will be 5 inches deep on each side 5'' on the top and 5'' on the botom of each wing. you need to add a feet in the total leight to bend it on the buckles.
the Carbon Cub in the picture used 5 feet of hook and loop, 2.5 on each wing.